You will need to visit your local dealer or locksmith to have your remote programmed to your car using diagnostic equipment. This keyless entry requires programming by your local dealer or locksmith. i have to jump the starter to get my car runing.good starter,new battery.now whe. Two buzz sounds, chimes or doors locking and unlocking 2 times should be heard at this point signaling successful programming. alarm,and starter problems - my problems: my p5 WONT START w/ignition key. Check the Pink ground wire for the VTCS solenoid valve back to terminal 73 of the Engine Control Module (ECM). Unplug and ohm the VTCS solenoid valve - specification is 22 - 26 ohms. If there are 2 transmitters, repeat this step 2 more times using the 2nd remote.ħ. Check the White/Red wire for good battery voltage to the VTCS solenoid valve with the key ON. If there is only one transmitter, repeat this step 2 more times using the only transmitter. A buzz sound, chime or doors locking and unlocking should be heard at this point signaling that vehicle has accepted the new transmitter code. New car program benefits Bumper-to-bumper 48 months/50,000 miles Corrosion 60 months/unlimited distance Powertrain 48 months/50,000 miles Roadside assistance 48 months/50,000 miles All model. Push any button on the transmitter 2 times. A mechanic told me that its recommended to replace a timing belt at 60,000 miles. If not, wait 40 seconds and return to step 4.Ħ.All transmitters need to be programmed at this time, including the old ones. 2002 mazda protege: its recommended to replace a timing belt at 60 I have a 2002 mazda protege with 73,000 miles on it. Push driver door frame button three times (black rubber button located onĭriver door frame that tell the vehicle whether or not door is closed.)ĥ.Buzz sound, chime or doors will lock and unlock should be heard at this point signaling that the vehicle is now in programming mode. Click on the PROGRAMMING TAB above for manufacturer programming requirements.Īdditional Information Attention: Interchangeable part # Model#: 41337ġ.(Optional - depends on trim level or option package installed) Remove key from ignition.Ĥ.Perform the following steps within 24 seconds.Į. Programming: This remote will need to be programmed to your vehicle in order to work with your vehicle. RKE (remote keyless entry)system once programmed.Ĭompatibility: FCC ID/Part number on your CURRENT MUST match with the FCC ID and part # in this listing (see below). This is ONE (1) NEW keyless remote control transmitter that will work with your vehicle s compatible Factory Original Equipment O.E.M.
0 Comments
Leave a Reply. |